Videx VX2200 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 36)

PAGE 36 of 68 VX2200 TECHNICAL MANUAL VER1.5

19 LD

Auxiliary LED +12V input (LED next to door open button)

20 GND

Ground

PROGRAMMING

Setup is carried out using the push buttons on the front of the unit and the dip-switches located on the rear of

the unit. An eight way dip-switch bank is used to set the address of the apartment as shown in the

decimal/binary conversion chart in this manual. Additionally there is a 4 bank dip switch which is used to

select the video type (either coaxial or balanced video twisted pair).

4 WAY DIPSWITCH

1 2 3 4 Video Mode

ON ON OFF ON Coaxial video (V2 = V, GND = Screen)

ON ON ON OFF Balance video (V1 & V2)

Switches 1 and 2 adjust the video signal impedance. When using more than one video monitor in series

without a video splitter put both switches in the OFF position on all but the last video monitor (end of line).

Number of rings (Factory default = 6 rings)

 Press and hold (for approx 10 seconds) “

” until the LED next to the button illuminates and the unit

emits a beep.

 Press “

” again as many times as the number of rings required (i.e. 6 times = 6 rings, maximum 9

times).

 Once the value of rings has been reached, wait 5 seconds for a beep and the LED turning OFF.

 The new value is stored.

Privacy duration time (Factory default = No time out)

 Press and hold (for approx 10 seconds) “

” until the LED next to the button illuminates and the unit

beeps.

 Each time the “

” button is pressed; it will increase (starting from 0) the privacy duration by 15

minutes.

 Press until the required duration has been reached, when reached, wait 5 seconds for a beep and

the LED turning OFF.

 The new time will be stored.

 To set the privacy with no time out (privacy enabled or disabled only by pressing the “

” button),

don't press any buttons once in privacy programming mode and wait 5 seconds for the beep and

LED to go off.

Call tone melody (Factory default = melody 1)

 Press and hold “●●” (or “

“on the SL5478) for approx 10 seconds until the LED next to the button

illuminates and the unit plays the current programmed melody.

 Press again “●●” (or the “

“ on the SL5478) to listen to the available melodies (9 Available). Once

the chosen melody has been reached, wait 5 seconds for a beep and the LED turning OFF.

 The new melody will be stored

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

Videx VX2200 Anleitung zur Fehlerbehebung Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen Videx VX2200